Purchase now: Pfannenberg 13245041055 DTI 6201 Cooling Unit
Purchase now: Atlantech Drives provides you the Pfannenberg 13245041055 (Model: DTI 6201), a highly efficient 1000 Watt Cooling Unit from the DTI series. This unit utilizes the Partially Recessed mounting method, integrating the cooling body directly into the enclosure door or side wall. This design minimizes the external footprint, making it the preferred choice for narrow aisles or mobile machinery where protruding «Side Mount» (DTS) units are a hazard.
Closed Loop Cooling for Critical Electronics
The DTI 6201 delivers 1000 W (L35/L35) of cooling power, sufficient for standard single-bay enclosures housing PLCs, HMIs, and mid-sized drives. It operates on 230 V AC (50/60 Hz) and maintains a sealed loop, separating the dirty ambient air from the clean internal air (IP 54). The wide condenser fin spacing ensures reliable operation even in environments with airborne dust or oil mist, reducing maintenance frequency compared to micro-channel condensers.
- Part Number: 13245041055.
- Model: DTI 6201.
- Cooling Capacity: 1000 W (L35/L35).
- Voltage: 230 V AC.
- Mounting: Recessed (DTI).
- Refrigerant: R134a.
- Temp Range: +15°C to +55°C.
- Condensate: Integrated evaporation system.
Maintenance Expert Tips: Condensate Management
The DTI 6201 features an integrated condensate evaporator that burns off moisture generated during cooling. Maintenance Advice: However, if the cabinet door is left open or the seals are bad, excessive humidity will overwhelm the evaporator. Always verify the integrity of the door gasket. Also, ensure the safety drain hose is routed correctly to the floor. If you see water pooling at the bottom of the cabinet, it usually means the ambient humidity is entering through a cable gland leak, not a failure of the AC unit.
Frequently Asked Questions (FAQs)
Q: Does it fit the same cutout as the larger units?
A: The DTI 6201/6301/6401/6501 series often share similar cutout geometries, allowing for scalable cooling designs, but always verify the exact template provided in the manual before cutting.
Q: Can I change the temperature setpoint?
A: Yes, the Standard Controller (SC) is factory set to +35°C, but can be adjusted via DIP switches or the display interface (depending on the exact controller version) to suit your specific component requirements.
Do you need more references from this brand? Explore our full catalog of Pfannenberg here.
